Hydraulic Press Design by size Optimization Method and FEA Solution

Authors

  • Verma K Deptt. Of mechanical Engineering, SGI Bhopal
  • Pardhmi M Deptt. Of mechanical Engineering, SGI Bhopal

Keywords:

CAD, Finite Element Analysis

Abstract

Metal forming is a process which is done by deforming metal work pieces to the desired shape and size using pressing or hammering action. Hydraulic presses are being used for forming and pressing operations with wide range of capacities. Hydraulic press machine works under continuous impact load. Because of this continuous load, tensile and compressive stresses are experienced in various parts of machine. These stresses cause permanent deformation in some parts of machine. This work is based on optimization of a 250-ton four pillar type hydraulic press considering constraints like design, weight and cost. The work is focused on design and optimization of top plate of the press machine. Top plate holds the hydraulic cylinder and is one of the most critical parts of the machine. The design is based on sizing optimization method and the results are validated by Finite Element Method with proper boundary conditions. The CAD modeling has been carried out by PTC CREO and for FEA, ANSYS software is used. Design Optimization of Hydraulic Press Plate using Finite Element analysis.

References

N. A. Anjum, M. Shah, S. Mehmood, W. Anwar, S. Anjum, M. S. Khalil (2017) “Design, Fabrication and Manufacturing of 100 Ton Hydraulic Press to Perform Equal Channel Angular Pressing (ECAP)” Technical Journal, University of Engineering and Technology (UET) Taxila, Pakistan Vol. 22 No. II-2017

Sayeed Rushd; Ashraful Islam; and R. Sean Sanders (2017) “CFD Methodology to Determine the Hydrodynamic Roughness of a Surface with Application to Viscous Oil Coatings” J. Hydraul. Eng., 144(2): 04017067

Gourav Suresh Kanhe, Dr. C. N. Sakhale (2017) “Design and Analysis of Sheet Bending Machine” IJSRD - International Journal for Scientific Research & Development| Vol. 5, Issue 02, 2017 | ISSN (online): 2321-0613

Harshad Khairkar, Mr. Dhananjay Kopre, Mr. Saurabh Kalkar, Dipali Kambe, Prof. Sarang Gulhane (2017) “Fabrication of automatic hydraulic bending and bend removing machine” International Research Journal of Engineering and Technology (IRJET) e-ISSN: 2395 -0056

Akbar H Khan, Pravin K Ghule, Ranjit P Shingare (2017) “Design Development and Experimental Study of Pipe Bending Machine” Journal of Industrial Engineering and its Applications

R. Sanjay S. SreyasAnand Tamilselvan Senthilkumar G. Vignesh M. Sathish Kumar (2017) “Design and Fabrication of Hydraulic Pipe Bending Machine” National Conference on Recent Advancements in Mechanical Engineering (RAME’17)

Thokale Manoj, Kothwal Satish, Kotkar Rahul, More Suyog, Pawase Mahesh (2017) “Design and fabrication of pneumatic bar bending machine” International Research Journal of Engineering and Technology (IRJET) e-ISSN: 2395 -0056

Downloads

Published

2017-12-30

How to Cite

Verma, K., & Pardhmi, M. (2017). Hydraulic Press Design by size Optimization Method and FEA Solution. Universal Research Reports, 4(11), 1–10. Retrieved from https://urr.shodhsagar.com/index.php/j/article/view/326

Issue

Section

Original Research Article